Septic Repair in Shelbyville TN

Mac Septic handles septic system repairs in Shelbyville TN for pump failures, baffle installation, distribution box repair, and aerobic system diagnostics. Call 615-345-2544 for same-week scheduling and honest pricing.

Need septic service in Shelbyville TN now?

Call (615) 345-2544

Septic prices in Shelbyville

ServicePrice
Septic pump-out, up to 1,000 gallons, within 40 miles of Columbia$650
Septic pump-out, up to 1,000 gallons, more than 40 miles from Columbia$700 to $725
Night, weekend or holiday pump-out, within 40 miles$975
Septic inspection, on its own$250
Septic inspection, added to a pump-out$200
Labor beyond the pump-out (digging, locating, extra work)$150 an hour

Shelbyville is about 35 miles from our Columbia base, so most addresses fall in the within 40 mile price. We confirm the price for your address when you call. Prices are stated up front. If the job needs more than the pump-out (a buried lid, hard-set solids), we tell you the cost before the work starts.

A Mac Septic truck hose connected to an open septic tank

Common repair scenarios

Pump motor replacement: $3K to $5K.
A submersible pump motor fails when impellers are damaged or the motor burns out. Replacement includes a new pump, installation, testing, and a one-year warranty on the pump itself.

Baffle installation or replacement: $150 per hour.
Inlet and outlet baffles keep solids in the tank and protect the drainfield from clogging. A baffle job typically takes 2 to 3 hours depending on tank access and whether solids need removal first. We recommend baffle installation whenever you have the tank open (for pump-out, lid access, or pump replacement).

Distribution box repair: $150 per hour.
The distribution box splits effluent across the drainfield laterals. If it cracks or tilts, effluent flows unevenly and one side of the field can clog. Repair or replacement is priced at $150 per hour with a 2-hour minimum.

Aerobic system (ATU) alarm and float diagnostics: $150 per hour.
Alarms on Norweco Singulair, Clearstream, Jet, Hoot, and Aqua-Safe systems often signal a failed aerator, float, or pump. We diagnose the issue and recommend repair or replacement. Typical diagnostics run 2 to 3 hours.

How we price repairs

Every repair is quoted before work starts. We charge $150 per hour for labor on most jobs. Pump replacement is priced as a unit ($3K to $5K) because the work is straightforward and the price is stable. We measure the job on site, tell you the cost, and confirm before we begin.

We never surprise you at invoice time. Pricing is stated up front in plain English.

Diagnostic first

If you hear an alarm or see a backup but you do not know what is failing, call for a diagnostic. We locate and assess the issue without committing to the full repair. Diagnostic-only service is $150 per hour with a 2-hour minimum ($300 total). Once we know what is broken, we quote the repair work and you decide.

Pump failure warning signs

A pump that is failing usually shows these signs: alarms on aerobic systems; slower drainfield absorption; gurgling sounds in the tank; or water backing up into the house. Do not delay. A failing pump means effluent is not flowing to the drainfield, which means it is backing up into the system. That can trigger a drainfield failure or a full system replacement if left too long.

The $3K to $5K pump replacement is expensive, but a $6K to $10K drainfield replacement is worse. Early diagnosis and repair save money.

Baffle damage

Baffles can crack if a tank is pumped too roughly or if solids are pushed hard against them. A damaged baffle means solids flow directly into the pump and out to the drainfield. That clogs the field within months. If you notice slow absorption or unusual drain behavior after a pump service from another company, call us for a baffle check.

After-hours emergency repairs

For weekend or holiday emergencies, we respond the same day within 2 hours. After-hours labor is 1.5 times the standard rate (so $225 per hour instead of $150). Pump replacements and other unit pricing scale the same way.

FAQ

How long does a pump replacement take?
Installation typically takes 3 to 4 hours depending on tank depth and access. We handle the entire job in one visit.

What if I need a baffle and do not know how to access the tank?
We handle tank opening, pumping if needed, baffle work, and cleanup. For a buried tank, we can locate and excavate the lid if it sits deeper than 6 to 8 inches (priced at $150 per hour).

Can you repair my ATU system if I do not know the brand?
Yes. We service Norweco, Clearstream, Jet, Hoot, and Aqua-Safe units. Bring documentation or photos if you have it; we can usually identify the system on site.

What if the repair is more expensive than I expected?
We quote before starting. If you decide not to proceed, there is no charge for the diagnostic and quote.

Service area

Shelbyville is about 35 miles south of Columbia in our core zone. Same-week scheduling is standard. We also serve Bedford County and surrounding areas with a small travel fee for properties outside our core radius.


Related septic services in Shelbyville TN

View all septic services in Shelbyville TN


References

County and state authorities cited on this page. County rules change; contact your county environmental health office for the current requirements.

State of Tennessee

Verified 2026-05-11.

Ready to schedule, or have a question?

Call us at (615) 345-2544 or use the contact form. Same-day or next-day in most cases.

Call now